Moose LED

Arm
[1] + Code
Disarm
[1] + Code
Check Faulted Zones
Lift cover on keypad.
Press [2], then your code.
For 8 seconds, lights become zone display lights.
Code Change
Press [9] + Master Programming Code. Panel will beep twice, all lights will blink.
[Press # corresponding to user number you want to add/change], Panel will beep 3 times.
[Enter 5 digit new code] (shorten code by putting zeros after code) after 5th digit panel will beep one long beep.
Power Down Panel
Open panel door. Slide power switch down (black switch located lower left corner of circuit board.)